Tag Archives: Meade 8″ SCT OTA

De-Forking a Meade 8″ SCT OTA

This sound a bit obscene but I promise that no animals, people or telescopes were harmed in the process.

The Meade SCT in question is an 8″  2080 model that I purchased around 1992. I used it quite a bit for a number of years until my interest turned to astrophotography. The specific model do not have a dec motor and the RA motor is running off 240VAC.

img_2775Over time I build an invertor that could work from AC or 12VDC and allowed me to vary the frequency  around the nominal 50Hz and I could therefore do some manual guiding in RA with a set of buttons and with the existing fine controls on the DEC. It worked a treat for a while but anybody that has guided long exposures manually will know that its a very tedious exercise with unpredictable results.

Well, now everything has changed. The new Skywatcher EQ6-R can easily carry the 8″ OTA (Optical Tube Assembly) as well as my ED 80mm and new opportunities becomes available.

I had to de-fork the OTA out of the Meade fork mount to allow me to fit a Losmandy plate to allow for the OTA to be fitted to the EQ6-R. There are a lot of guidance on the web for how to do this but I used the following site:

http://uncle-rods.blogspot.com.au/search?q=getting+deforked

Its remarkable easy and took no time at all.

Loosen two bolts on one of the arms first.

img_2778

Then remove three small bolts from each side of the tube. Take care to work on a soft surface and have someone assist you to make sure you don’t scratch the tube surface.img_2779

And its off!img_2780

Now to mount the Losmandy DM8 kit into the existing holes on the OTA.img_2783

10 minutes later…img_2784 img_2785 img_2786

And now the amazing Meade 8″ OTA can be used on a very capable and accurate mount. A big change for me and there should be some new images soon.

img_2788With my luck it will probably be cloudy and rainy for a month now ….

Advertisements